I would have thought that this was a common issue with mailmerge address fields but have searched here and googled and I can only seem to find similar questions with no solutions attached. I think I'm getting close to working it out but it's driving me mad! ![]() This worked in scenarios where the address was 5 lines but if more or less, it would not behave and would either not show the postcode at all, OR show it twice. I have tried setting up if then else rules and I made the assumption that all addresses would have at least 3 lines included so the first rule in place was Obviously if all addlines are used, it looks fine. Where the address only has addlines 1-4 and a postcode, I'm getting blank lines between addline4 and the postcode. The following example demonstrates how to create a form. The Mail Merge pane will appear and guide you through the six main steps to complete a merge. ![]() From the Mailings tab, click the Start Mail Merge command and select Step-by-Step Mail Merge Wizard from the drop-down menu. I have a document that has 7 mailmerge address fields addline1, addline2, addline3, addline4, addline5, addline6, Postcode. To use Mail Merge: Open an existing Word document, or create a new one. I have been looking into this all morning and am really hoping there is a simple solution to this.
0 Comments
Leave a Reply. |